ClonBrowser

Step1: Preparation


Before integration, you need to complete the following preparations

1

Download and install ClonBrowser

2

Get the proxy IP, please refer to the tutorial

Dynamic Residential API Extraction

Dynamic Residential Account and Password Authentication

Step2: Proxy Configuration


API Configuration


API configuration is authenticated through the IP whitelist. Please make sure that you have added the local IP to the whitelist before configuration

Please refer to the tutorial for adding a whitelist:

1. Click New Browser

image.png

2. In the proxy position, click New to enter the proxy configuration interface

image.png

3. Select the protocol according to the needs. Here, take http as an example. Fill in the IP and port in the corresponding position, click Detect, and click Save after the detection is successful

image.png

4. Click New Browser again to enter the configuration interface, and click Select in the proxy position

image.png

5. Select the proxy you just configured and click Confirm

image.png

6. As shown in the figure, the proxy selection is successful, click Create Browser

image.png

7. You can see it in the browser interface The browser that has been successfully configured, click Open to use

image.png

Account and password configuration


1. Click New Browser

image.png

2. In the proxy position, click New to enter the proxy configuration interface

image.png

3. Select the protocol according to the needs. Here, take socks5 as an example, and fill in the IP, port, account, and password in the corresponding position

image.png

4. Click Connect Test. After the detection is successful, click Save

image.png

5. Click New Browser again to enter the configuration interface. Click Select in the proxy position

image.png

6. Select the proxy that has just been configured and click Confirm

image.png

7. As shown in the figure, the proxy is successfully selected. Click Create Browser

image.png

8. You can see the successfully configured browser in the browser interface. Click Open to use

image.png

You have successfully integrated LunaProxy with ClonBrowser!


Last updated

Was this helpful?